CORE Generator Options:
   Target Device                   : xc7k410t-ffg900
   Speed Grade                     : -2
   HDL                             : verilog
   Synthesis Tool                  : Foundation_ISE

MIG Output Options:
   Module Name                     : ddr3_interface
   No of Controllers               : 1
   Selected Compatible Device(s)   : xc7k325t-ffg900

FPGA Options:
   System Clock Type               : Single-Ended
   Reference Clock Type            : No Buffer
   Debug Port                      : ON
   Internal Vref                   : disabled
   IO Power Reduction              : ON
   XADC instantiation in MIG       : Enabled

Extended FPGA Options:
   DCI for DQ,DQS/DQS#,DM          : enabled
   Internal Termination (HR Banks) : 50 Ohms
    
/*******************************************************/
/*                  Controller 0                       */
/*******************************************************/
Controller Options :
   Memory                        : DDR3_SDRAM
   Interface                     : AXI
   Design Clock Frequency        : 2000 ps (500.00 MHz)
   Phy to Controller Clock Ratio : 4:1
   Input Clock Period            : 10000 ps
   CLKFBOUT_MULT (PLL)           : 10
   DIVCLK_DIVIDE (PLL)           : 1
   VCC_AUX IO                    : 1.8V
   Memory Type                   : Components
   Memory Part                   : MT41J256m16XX-125
   Equivalent Part(s)            : MT41J256M16HA-125
   Data Width                    : 32
   ECC                           : Disabled
   Data Mask                     : enabled
   ORDERING                      : Normal

AXI Parameters :
   Data Width                    : 128
   Arbitration Scheme            : ROUND_ROBIN
   Narrow Burst Support          : 1
   ID Width                      : 4

Memory Options:
   Burst Length (MR0[1:0])          : 8 - Fixed
   Read Burst Type (MR0[3])         : Sequential
   CAS Latency (MR0[6:4])           : 7
   Output Drive Strength (MR1[5,1]) : RZQ/7
   Controller CS option             : Enable
   Rtt_NOM - ODT (MR1[9,6,2])       : RZQ/4
   Rtt_WR - Dynamic ODT (MR2[10:9]) : Dynamic ODT off
   Memory Address Mapping           : BANK_ROW_COLUMN


Bank Selections:

System_Clock: 
	SignalName: sys_clk_i
		PadLocation: AD17(SRCC_P)  Bank: 32

System_Control: 
	SignalName: sys_rst
		PadLocation: No connect  Bank: Select Bank
	SignalName: init_calib_complete
		PadLocation: No connect  Bank: Select Bank
	SignalName: tg_compare_error
		PadLocation: No connect  Bank: Select Bank